Slotted dancing is where you are dancing from point A to point B, at either end of the slot - like you do in all (?) MJ classes. If there is space, the slot can widen - with the travel going perpendicular to the original slot, though you normally return to the original slot. Keeping your bearings is easy in most venues - because they tend to be rectangular, the circular venues are more of a problem!
At a friend's party recently, I was grabbed for a dance by a young lady I didn't know, after a minute or so she asked "What are we doing?"
My stock answer to something like this (because it's true!) "I don't know."
She said "We seem to be walking up and down?"
My reply "Oh, I do a lot of West Coast Swing."
"Oh no! I Don't do that, I only do jive, where you go round and round. "
I just managed to hold back from having an apoplectic fit!
So for me, after years of "going round and round" it has to be slotted. It's safer, more stylish (IMO), gives you more space, and probably easier. Of course it doesn't stop you doing circular moves, but you return to the slot by going round a half or full circle, as you would in the lesson.
DavidB wrote:So what is the best way of squeezing more people on the floor.
Less than 2.5 square metres, and something has to give.
- You can shorten the connection to make the circle smaller. A 1.5 m circle and you can get almost 50 couples on the floor without bumping, or 55 with.
- You can take the WCS idea of dancing in a slot - you can still move a lot, but the man has to be better at controlling the lady's direction (A 2m by 1m slot and you get 50 couples on the 10 by 10 m floor.)
- Or do both, and you get 65 couples on the floor.
So it might be better to suggest to people to dance in a slot as the floor gets busier, and make the most of the available room.
Katie wrote:He has encouraged people to dance in a slot as you take up less room. Every jive lesson is taught in a slot in order to maintain the rows and if dancers choose not to use this in freestyle, then there will be less floor space.
Kate